Experience

ThermaPlate Heat Exchangers

• United States
• Mechanical Or Industrial Engineering
• 1 - 100 Employee

• Mechanical Design Engineer

  • Jun 2021 - Present

  • Assisted in Thermaplate receiving an ASME U & R stamp and National Board of Boilers and Pressure Vessel Inspectors Accreditation. Contributed to writing the weld procedures and the weld demonstration for the inspection. • Did initial testing on a Janda Multi-head Welder to ensure the pillow plates could reach the intended burst pressure to meet a necessary minimum pressure for marketing. • Design shop layout to help ensure a one way flow throughout the shop. • Developed codes in .csv for the Multi-head Welder using a Pinch Point Saftey Systems controller. These codes make it so the Multi-head can weld full plates with minimal human interaction. • Developed weld schedules for the Multi-head and Seam Welder. The controls used are Weld Computer, and Janda J700 and J800 controllers. • Built drawing standards for customer-facing and shop drawings. • Design and Draw approval drawings for potential clients. • Am able to run the following machines in the shop: Shear, Overhead Crane, Multi-head welder, and Seam Welder. I am the primary operator on both machine welders and run them for ASME jobs. • Check-in and log material that comes into the shop following ASME standards. Standards most often followed are SA-240, SA-182, SA-479, and SA-312. • Inflate and leak test pillow plates during production. • QA plates throughout the process of production. • Assist in creating and loading finished plates for shipping. Show less



Lummus Corporation

• United States
• Machinery Manufacturing
• 1 - 100 Employee

• Sustainability Engineer

  • Apr 2019 - Apr 2020

  • Support Lean Manufacturing • Worked as the intermediary between Design Engineering Department and the Manufacturing floor • Supported in design work • Support Lean Manufacturing • Worked as the intermediary between Design Engineering Department and the Manufacturing floor • Supported in design work



US Department of Agriculture (USDA) Agricultural Research Service (ARS)

• Research Services
• 700 & Above Employee

• Engineering Assistant

  • May 2018 - Apr 2019

  • Assisted on design of the original VIPR system. A camera system that detected and ejected plastic contamination found in the cotton stream. This project was picked up by Bratney Companies and is currently in final market testing. • Assisted on designed and installed a camera system for the module feeder to detect plastic entrapment, an active prototype was deployed into the field. This project is continuing to be researched. • Assisted on design of the original VIPR system. A camera system that detected and ejected plastic contamination found in the cotton stream. This project was picked up by Bratney Companies and is currently in final market testing. • Assisted on designed and installed a camera system for the module feeder to detect plastic entrapment, an active prototype was deployed into the field. This project is continuing to be researched.



The University of Texas at San Antonio

• United States
• Higher Education
• 700 & Above Employee

• Grader for Thermodynamics 1

  • Jan 2018 - May 2018

  • Taught 4 recitations a week on thermodynamics 1. • Held office hours to help students with problems on homework. • Taught lectures when Dr. Karimi was unavailable. • Taught 4 recitations a week on thermodynamics 1. • Held office hours to help students with problems on homework. • Taught lectures when Dr. Karimi was unavailable.