Experience

HORIBA Scientific

• Research Services
• 700 & Above Employee

• Software Application Engineer

  • Jul 2015 - Present



Bosch

• Germany
• Software Development
• 700 & Above Employee

• Engineering Technician

  • Dec 2011 - Jul 2014

  • Directed associates for set up of engines and instrumentation for starter motor testing. • Collaborated with engineering personal to ensure all proper testing protocols were met. • Performed FMEA and DVP&R’s for tested parts. • Programmed and modified test procedures. • Planned testing activities with customers. • Participated in teams and cross-functional groups. • Responsible for the diagnosis of Test Stand problems • Directed the design and building of tools and equipment • Analyzed product variations, planed and implemented process improvements. • Performed data acquisition & control hardware diagnostic activities Show less



General Motors

• United States
• Motor Vehicle Manufacturing
• 700 & Above Employee

• Engineering Technician

  • Jul 2011 - Dec 2011

  • Assembled and instrumented engine assemblies per engineering direction. • Responsible for integrating engine into engine dyno pallet assembly. • Instrumented engine assemblies per engineering direction. • Installed and trouble shot vehicle data acquisition instrumentation. • Published technical reports detailing problems encountered and the solutions implemented. • Assembled and instrumented engine assemblies per engineering direction. • Responsible for integrating engine into engine dyno pallet assembly. • Instrumented engine assemblies per engineering direction. • Installed and trouble shot vehicle data acquisition instrumentation. • Published technical reports detailing problems encountered and the solutions implemented.



Demand Detroit

• Motor Vehicle Manufacturing
• 700 & Above Employee

• Engineering technician

  • Jun 2009 - Jan 2011

  • Performed calibration changes to optimize engine emissions for cold environments. • Tested and maintained heavy duty diesel engines, diesel oxidation catalyst (DOC), diesel particulate filters (DPF) and Selective Catalytic Reduction (SCR) emissions devices in performance test cells, durability test cells and cold chamber test cell. • Worked with engineering in establishing their emissions and instrumentation testing needs and assuring that those needs were fulfilled. • Documented and resolved all reported test data issues. • Set up INCA and ETAS diagnostic equipment for PCM communication • Knowledgeable about diesel engines and testing electronics • Experienced with engine emissions measurement practices. • Knowledge of U.S. EPA and California Air Resources Board emission requirements • Responsible for the diagnosis of engine issues. • Performed fabrication as necessary to complete test cell engine and after treatment setups. Show less