Experience

Pong Codan Rubber Malaysia

• Malaysia
• Motor Vehicle Manufacturing
• 1 - 100 Employee

• Assistant Production Manager

  • May 2016 - Present

  1. Budgeting: Provides estimates to the finance department for purchase of materials, equipment and hiring laborers for the facility.2. Procurement of raw materials and machinery: Look after the purchase of equipment and raw materials. Checks the quality of materials and equipment before they are installed or used in the facility.3. Allocating resources and duties: Assigns resources and duties to the production staff in the facility according to the production requirements and competency of the staff.4. Place orders to vendors: Places orders to the vendors regarding material and equipment requirements. Keep an updated record of all the purchases and maintain adequate stocks to keep the production process running even if there is a shortage of materials with the vendors.5. Identify and resolve labor and production conflicts: Assists the laborers and resolves any conflicts that might surface during any phase of the production. Communicates with the engineers and technicians regarding any problems in the equipment and gets it repaired to avoid any delay in the production.6. Hiring and training: Participates in the hiring of production staff and provides training on the use of equipment to the new staff and existing staff for new machines. Show less

• Process Engineer

  • May 2014 - May 2016

  1. Responsible for setup & update of working instruction, SOP, part identification sheet for manufacturing process.2. Responsible for monitoring & assist production to carry out their task.3. Responsible for design, fabrication, modify & trial out of production equipment, mould, jig & fixtures.4. Responsible for preparing production floor process layout plan, work out manpower planning based on Takt time study.5. To conduct capability & capacity study, process flow & Takt time study for new and existing production line.6. Responsible for improvement of process techniques, tools, machines and environment.7. Responsible for carry out Kaizen activities to reduce process rejection & wastage.8. Prepare process documentation, process tool / workstation and perform samples making.9. Responsible for handling product abnormality in Genba.10. Responsible for leading the embodiment of new development part in production line and conduct and monitor new part pilot run consistency of process before Pre-mass production.11. Responsible for monitoring condition of production jig / fixture & process tools.12. To setup production during installation of new equipment & trial run.13. Responsible to carry out TPS activities in production line continuously. Show less