Experience

Samco Machinery

• Canada
• Industrial Machinery Manufacturing
• 100 - 200 Employee

• Electrical Design Engineer

  • Apr 2022 - Present

• Electrical Design Engineer

  • Oct 2021 - Apr 2022



Hi-Tech Solutions

• India
• Security and Investigations
• 1 - 100 Employee

• Jr. Electrical Design Engineer

  • Nov 2017 - Nov 2018

  • Create and maintaining accurate Electrical drawings such as plan views of electrical equipment, Single line diagrams and panel schematics in E-plan P8 Electric and AutoCAD Electrical • Created wiring designs for electrical panels such as cable selection, sizing, and routing in E-plan P8 Electric & AutoCAD Electrical under supervision of Electrical Designer. • Develop final layout and wiring schematics and provide cost estimates. • Provide material specifications for wiring and other installations. • Discussed possible modifications with electrical engineers and architects and implemented them accordingly. • Performed Buzz Testing of electrical panels for commissioning the panel before installing and to locate the fault on abrupt halt of the panel. • Test wiring circuits and controls to isolate and locate causes for malfunctions, using electrical instruments, compliance with safety policies and procedures of the facility. Show less



Global Electrical Laboratory

• India
• Appliances, Electrical, and Electronics Manufacturing
• 1 - 100 Employee

• Electrical Technologist

  • Oct 2016 - Oct 2017

  • Construct & Install Wire Harness through reading Blueprints, Electrical Schematic and Circuit Diagram using electrical Equipment such as Crimper, pliers, Wire Stripper, Soldering iron, heat gun, Screwdrivers, and nut drivers specific to electricians. • Hands-on experience on wire routing, cut length, insulation strip and different color coding. • Testing all Wire Harness during Final assembly and Troubleshoot Problems using Multi-meter, Megger, Hi-pot Tester, Surge Tester. • Perform Continuity Test, Low Resistance Test, Impedance Test, Insulation test and Polarity Test to ensure the termination and the strength of insulation of the wires. • Programmed Digital Speedometer using Relays and Construct bottom dashboard according to the requirement. • Reconstruct the Blueprint and the schematic diagram using AutoCAD Electrical according to the client’s Requirement. • Designing Relay Connections for Main & Taillight Harness in AutoCAD Electrical & Preparing Electrical GA for the Equipment. • Construct and stock up the Main harness, Taillight Harness, Hydraulic Harness, Laser Wiring, and other parts which require to complete the Wiring. Show less