Experience

Wiwynn

• Taiwan
• IT Services and IT Consulting
• 500 - 600 Employee

• Product Mechanical Engineer

  • Apr 2022 - Present

  oSupport in internal induced product damage investigation root cause and failure mode analysis to propose solutions and containments. This activity implicates cost saving through scrap avoidance (Total scrap < 0.070%-ON GOAL) and technicians supervision. o Process validation trough strain gage analysis. o Support in fixture design for production assemblies issues. o Analysis for product potential failure modes for new product introduction. oSupport in internal induced product damage investigation root cause and failure mode analysis to propose solutions and containments. This activity implicates cost saving through scrap avoidance (Total scrap < 0.070%-ON GOAL) and technicians supervision. o Process validation trough strain gage analysis. o Support in fixture design for production assemblies issues. o Analysis for product potential failure modes for new product introduction.



Nidec Motor Corporation

• United States
• Appliances, Electrical, and Electronics Manufacturing
• 700 & Above Employee

• Product Engineer

  • Feb 2021 - Apr 2022

  o Component validation for VA/VE (Value Added/Value Engineered) and temporal use due to force majeure, aligning cost, feasibility, and analysis. o Establish technical feasibility and coordinate necessary prototype and production trial runs for prototype products for validations and Request for Quotes (RFQs) by writing Engineer Work Orders.o Aid in the launch and implementation of production lines for electrical motors.o Performed Process Validation Plans and worked to acquire customer approval. o Enhanced product design based on simulation and test data. o Lead ECR with 4M and DRBFM consideration. o Assist quality department with customer claims. Show less

• CAD Designer Engineer

  • Jun 2019 - Feb 2021

  o Creation and modification of 2D and 3D product drawings using CATIA to meet customer requirements, internal or supplier requests, and fixture creation. o Stack up analysis to support the design of manufacturing (DFM). o BOM structure creation for new product variants from customer specifications and new requirements.o Creation of new part numbers and drawings release through ECR and PLM system.

• Maintenance technician

  • May 2018 - Jun 2019

  o Support production line by providing technical support on preventive and corrective equipment problems.o Reduction of scrap and downtime avoidance through corrective and preventive maintenance. o Responsible in following Preventive Maintenance Schedule programs.



MAHLE

• Germany
• Motor Vehicle Manufacturing
• 700 & Above Employee

• Product engineering intern

  • Sep 2016 - Jun 2017

  o Performed metallographic sample preparation for root cause analysis of defective products and validation of finished product quality, including sample cleaning, cutting, mounting sample in epoxy resin, grinding, polishing, and etching of samples. o Performed metallurgical analysis such as microstructural characterization, porosity, joint and leak source analysis, and surface finish analysis (i.e., plating thickness). o Conducted macroscopic analysis such as visual inspection and dimensional analysis. o Technical support to the prototypes division for the construction of prototypes for validation test. o Support for product engineering with design reviews and product validation changes. Show less