Experience

Caltech

• United States
• Research Services
• 700 & Above Employee

• Graduate Student

  • Sep 2019 - Present

  Teaching assistant for two graduate-level courses: APh 114B (Solid-state physics: electronic and optical properties) APh 183 (Physics of semiconductors and semiconductor devices) Main courses taken: Mathematics: Introduction to Probability Models Bayesian Statistics Fundamentals of Statistical Learning Learning Models Electrical Engineering, Applied Physics: Signal-Processing Systems and Transforms (I and II) Solid-State Physics (I, II, and III) Semiconductor Devices States of Matter Show less



attocube systems AG

• Germany
• Nanotechnology Research
• 100 - 200 Employee

• Research And Development Engineer

  • Sep 2018 - Sep 2019



University of Duisburg-Essen

• Education Administration Programs
• 700 & Above Employee

• Intern

  • Jun 2017 - Aug 2017

  -Set up interferometer for counterfactual communication measurement where a quantum dot was used both as the light source and the absorber in the system. -Took differential reflection and resonance fluorescence measurements to characterize the excitation energies of the quantum dot as well as increase signal contrast out of the quantum dot, with end goal being to use quantum dot as single photon source. -Fabricated transistors and contacts in clean-room. -Set up interferometer for counterfactual communication measurement where a quantum dot was used both as the light source and the absorber in the system. -Took differential reflection and resonance fluorescence measurements to characterize the excitation energies of the quantum dot as well as increase signal contrast out of the quantum dot, with end goal being to use quantum dot as single photon source. -Fabricated transistors and contacts in clean-room.



University of Basel

• Switzerland
• Research Services
• 700 & Above Employee

• Intern

  • Jun 2016 - Aug 2016

  -Helped assemble a fiber-based optical cavity setup. -Prepared fibers using the lab's cleaver/splicer and analyzed them with an AFM and confocal microscope. -Wrote code in Python to analyze CSV files collected from the confocal microscope, and output 3D best-fit model for craters made using a CO2 laser. -Modeled parts in SolidWorks for fiber shipment to a coating lab. -Helped assemble a fiber-based optical cavity setup. -Prepared fibers using the lab's cleaver/splicer and analyzed them with an AFM and confocal microscope. -Wrote code in Python to analyze CSV files collected from the confocal microscope, and output 3D best-fit model for craters made using a CO2 laser. -Modeled parts in SolidWorks for fiber shipment to a coating lab.



attocube systems AG

• Germany
• Nanotechnology Research
• 100 - 200 Employee

• Intern

  • Jul 2014 - Aug 2014

  -Built an interferometer and measured nm-scale displacements produced by a piezo-actuator. -Used measurements to determine the piezo-actuator's hysteresis and assess its functionality. -Wrote report entitled Piezo HeNe Interferometer detailing work. -Built an interferometer and measured nm-scale displacements produced by a piezo-actuator. -Used measurements to determine the piezo-actuator's hysteresis and assess its functionality. -Wrote report entitled Piezo HeNe Interferometer detailing work.