Experience

Zinwave

• United Kingdom
• Wireless Services
• 1 - 100 Employee

• Graduate Electronics Hardware Engineer

  • Sep 2023 - Present



CML Micro

• United Kingdom
• Semiconductor Manufacturing
• 1 - 100 Employee

• Electronics Test Engineer

  • Aug 2022 - Nov 2022

  • Designing test hardware and writing test software for use in production • Testing PCB assemblies to documented procedures • Calibration of test equipment to documented procedures • Maintaining test hardware and fault finding to component level • Designing test hardware and writing test software for use in production • Testing PCB assemblies to documented procedures • Calibration of test equipment to documented procedures • Maintaining test hardware and fault finding to component level



Trinity Workshops Ltd

• Wethersfield

• Junior Electronics Engineer

  • Mar 2019 - May 2019

  • Tested an intelligent battery management system (MMP IQ Box 2) by using software and bench tools • Tested a forensic imaging device (MediaBox4) by using software and bench tools • Crimped and placed both ends of wires into connectors. Soldered wires on to a connector • Disassembled, assembled, tested and logged new test methods for a router. Removed the chassis from products • Upgraded and setup the BIOS, installed the operating system, and tested USB on UP Squared • Identified faults on a PCB Show less



Anglia Ruskin University

• United Kingdom
• Higher Education
• 700 & Above Employee

• Project experience in my degree

  • Sep 2014 - May 2018

  Final year degree independent project: Controlling the navigating of a moving platform (robot) to its target using Field Programmable Gate Arrays: implemented fuzzy logic controllers using VHDL (by using Vivado and Xfuzzy) and built a physical robot prototype that could move. Projects undertaken during each year of degree: • Year 1: resistance (Ohm) calculator, one C program to control a stepper motor and another to control a buzzer, program to control a Siemens programmable logic controller, construct and simulate digital electronic circuits, construct and simulate analogue electronic circuits (filters) • Year 2: room thermometer data acquisition system, hardware design and build for team project on security system, signal encoders and decoders created using MATLAB, accelerometer-based microprocessor system using mbed to sense 3D tilt of an object • Year 3: wirelessly controlling a DC motor using a smartphone (Internet of Things Conveyor Belt Controller), FPGA based room thermometer, construct and analyse control systems in MATLAB Show less



P.A. Davall Carpenter & Joiner

• Carpenter's Assistant

  • Jul 2013 - Sep 2014

  • I was friendly and polite towards customers and was responsible for cleaning up after tradesmen • Worked as part of a team and independently on site and assisted with the customer’s enquiries • Typed up estimates and invoices and emailed / posted them • Managed the site when required Also worked June 2012 – May 2013 and July 2007 – July 2008. • I was friendly and polite towards customers and was responsible for cleaning up after tradesmen • Worked as part of a team and independently on site and assisted with the customer’s enquiries • Typed up estimates and invoices and emailed / posted them • Managed the site when required Also worked June 2012 – May 2013 and July 2007 – July 2008.



Co-operative Food

• Customer Service Assistant

  • Oct 2008 - Sep 2011

  • I used a computerised till for handling customer transactions in a shop • I worked as part of a team and kept the shop floor and staff area tidy • I maintained a high level of customer service and approachability in the shop and listened to and handled customer enquiries • I unpacked and put out the stock • I tidied all the stock to ensure that the shelves were attractively presented • I checked customer’s acceptable photo ID and served age-restricted products only if person was 18 or over (customer must show acceptable ID if looks under 25) Show less