Experience

Electronic Technologies International, Inc.

• United States
• Appliances, Electrical, and Electronics Manufacturing
• 1 - 100 Employee

• Maintenacne Technician

  • Jun 2014 - Present

  Am responsible for the installation, maintenance and repair of several types of machines used in the wire cutting and processing industry. I work on Panduit air powered crimpers, Molex crimpers and Schaffer. I am responsible for maintaining our Gamma 333 pc based wire processing stations. I also take care of an Artos 327, a Kappa 235 and a Kappa 240 wire cutters. I am also helping with the testing and repairing of several different pcb's that are made here. Am responsible for the installation, maintenance and repair of several types of machines used in the wire cutting and processing industry. I work on Panduit air powered crimpers, Molex crimpers and Schaffer. I am responsible for maintaining our Gamma 333 pc based wire processing stations. I also take care of an Artos 327, a Kappa 235 and a Kappa 240 wire cutters. I am also helping with the testing and repairing of several different pcb's that are made here.



CN

• Canada
• Rail Transportation
• 700 & Above Employee

• Communications Technician

  • Mar 2008 - Jan 2014

  Primary duties of the job were the installation and maintenance of all two-way radio units in various types of vehicles, programming of radios, repairing and maintaining radio dispatch towers and radios. Also worked on data collection equipment for tracking of railroad cars, sensor equipment for detection of failed cars on moving trains, but also responsible for maintaining company network in several facilities. Recently installed and setup a microwave network including Cisco routers and Alcatel network interface equipment. Covered a territory covering about 110 miles. Travelled between sites and to remote areas to work on mobile and stationary equipment with little to no supervision. Was responsible for time management and getting work done in a timely manner. Show less



SSI Technologies, Inc

• United States
• Mining
• 200 - 300 Employee

• Maintenance Technician

  • Mar 2006 - Jan 2008

  Responsible for maintaining, repairing, installing and setting up various pieces of equipment used in the production of sensors for use in the automotive industry. Worked on injection molding machines, automatic test benches and mechanical assembly stations. Was responsible for keeping equipment running and repairing in a timely manner those that broke down. Also worked with engineering to implement new test procedures, run verification tests on new products and install new test equipment. Show less



GE Healthcare

• Waukesha, WI

• CT Test Bay Technician

  • Feb 2005 - Feb 2006

  I was a contractor at GE for 12 months. While here I performed setup, integration, testing, configuration and repair of various types of Lightspeed CT units. Troubleshoot failed units to board level using schematics, test equipment and various troubleshoot techniques. Uses DCAS and NCR system to accurately report failures of system and failed components. Also am certified to work on and sign off, VCT units. I was a contractor at GE for 12 months. While here I performed setup, integration, testing, configuration and repair of various types of Lightspeed CT units. Troubleshoot failed units to board level using schematics, test equipment and various troubleshoot techniques. Uses DCAS and NCR system to accurately report failures of system and failed components. Also am certified to work on and sign off, VCT units.