Experience

Komatsu Germany GmbH - Mining Division

• Germany
• Machinery Manufacturing
• 100 - 200 Employee

• Development Engineer

  • May 2023 - Present

  Advanced development in the Team “New Technologies Development” Advanced development in the Team “New Technologies Development”



Wilo Group

• Germany
• Machinery Manufacturing
• 700 & Above Employee

• Master Thesis

  • Jul 2021 - Jan 2022

  Development and analysis of an observer for Parameter tracking of the model of the hydraulic behavior and power consumption of a pump unit Grade: 1.0 Development and analysis of an observer for Parameter tracking of the model of the hydraulic behavior and power consumption of a pump unit Grade: 1.0



Institute for Fluid Power Drives and Systems

• Germany
• Research Services
• 1 - 100 Employee

• Research Assistant

  • Jun 2019 - Jun 2021

  - Responsible for laboratory measurement series: optimization of measurement methods and development of new laboratory equipment- Induction of new PhD students and undergraduates- Main responsible for the execution of surface measurements- 19h/week

• Student Assistant

  • Jul 2018 - May 2019

  - Development of test bench controls and commissioning- Design of test bench and order processing of manufacturing- 10h/week



IME Aachen GmbH Institut für Maschinenelemente und Maschinengestaltung

• Germany
• Machinery Manufacturing
• 1 - 100 Employee

• Bachelor Thesis

  • Dec 2018 - May 2019

  Simulation-supported development of a drone-based measurement and Evaluation strategy for short-term forecasting of local wind fields Grade: 1.3 Simulation-supported development of a drone-based measurement and Evaluation strategy for short-term forecasting of local wind fields Grade: 1.3



Bosch

• Germany
• Software Development
• 700 & Above Employee

• Development Engineer

  • Apr 2018 - Jul 2018

  The project was intended for the development of high-pressure pumps for direct petrol injection. My main tasks were the test bench support and evaluation of the results. In this context, I programmed a tool with matlab that automates this evaluation. The project was intended for the development of high-pressure pumps for direct petrol injection. My main tasks were the test bench support and evaluation of the results. In this context, I programmed a tool with matlab that automates this evaluation.



Institute for Fluid Power Drives and Systems

• Germany
• Research Services
• 1 - 100 Employee

• Student Assistant

  • Oct 2016 - Apr 2018

  - Development of a co-simulation for the recuperation of a hybrid excavator - Set-up and commissioning of test benches - 10h/week - Development of a co-simulation for the recuperation of a hybrid excavator - Set-up and commissioning of test benches - 10h/week