Experience

Industrial Assessment Center at Oklahoma State University

• United States
• Mechanical Or Industrial Engineering
• 1 - 100 Employee

• Undergraduate Research Assistant

  • May 2022 - Present

  Stillwater, Oklahoma, United States Performed energy efficiency evaluations for small- and medium-sized manufacturers, water treatment plants, and wastewater treatment plants. Conducted site visits to take engineering measurements and received hands-on assessment training at industrial facilities. Analyzed industrial processes and generated detailed assessment recommendations concerning topics like insulation, peak demand management, and reactive power optimization. Communicated with clients through written technical reports and… Show more Performed energy efficiency evaluations for small- and medium-sized manufacturers, water treatment plants, and wastewater treatment plants. Conducted site visits to take engineering measurements and received hands-on assessment training at industrial facilities. Analyzed industrial processes and generated detailed assessment recommendations concerning topics like insulation, peak demand management, and reactive power optimization. Communicated with clients through written technical reports and presentations resulting in recommended direct energy savings of 32,304 MMBtu and $222,480. Show less



Baker Hughes

• United States
• Oil and Gas
• 700 & Above Employee

• Engineering & Technology Intern

  • May 2023 - Aug 2023

  Oklahoma City, Oklahoma, United States • Upgraded a test well as part of a project to retrofit non-productive oil and gas wells for geothermal energy. • Tested the insulation resistances and electrical resistances of 90 heating elements with a megohmmeter. Documented these values at each stage of the installation to identify and correct potential equipment damages. • Turned the heating elements on a lathe to reduce their diameter. Grouped the elements by resistance to balance three-phase power. Installed the elements on the… Show more • Upgraded a test well as part of a project to retrofit non-productive oil and gas wells for geothermal energy. • Tested the insulation resistances and electrical resistances of 90 heating elements with a megohmmeter. Documented these values at each stage of the installation to identify and correct potential equipment damages. • Turned the heating elements on a lathe to reduce their diameter. Grouped the elements by resistance to balance three-phase power. Installed the elements on the casing sticks, grouted them, and wired them together. • Machined fittings to minimize the galvanic corrosion of a capacitive level sensor. • Calculated calibration curves for twenty-three thermocouples. Wired thermocouple input modules for data acquisition. • Designed a bolt assembly to connect the wires between casing sticks and identified the appropriate torques. • Installed the casing sticks down the well. Tested insulation resistance periodically to identify sections damaged during installation and reinsulated them. Fed wires and thermocouples through a hanger to reach the surface. • Ran audio and visual for the 2023 Baker Hughes Energy Frontiers Summit, and participated in STEM outreach programs for Oklahoma City public schools. Show less



Oklahoma State University

• United States
• Higher Education
• 700 & Above Employee

• Undergraduate Research Assistant

  • May 2022 - Sep 2022

  Stillwater, Oklahoma, United States Supported experimental components of a thermal energy storage project through OSU's Building Air Conditioning and Heating Lab. The project aims to develop a system that includes thermal storage to deal with energy supply fluctuations.



Roll-2-Roll Technologies LLC

• United States
• Automation Machinery Manufacturing
• 1 - 100 Employee

• Design Engineering Intern

  • Sep 2021 - May 2022

  Stillwater, Oklahoma, United States Designed and implemented a three-dimensional frame to standardize accuracy in the sensor-testing process. Created models of sensor products and accessories using SolidWorks. Generated engineering drawings for use in product assembly instructions and those for customer reference during the product selection process. Manufactured a series of molds using additive manufacturing principles and 3D printing technology to quickly align sensor parts with several adjustable components.