Plausible Instruments Private Limited offers on-site hardness tester calibrations. PI uses Direct verification as per the applicable IS/ISO/ASTM Standards, Indirect verification as per the applicable IS/ISO & Verification of Test Cycle of all sorts of Hardness Testers. • Rockwell Hardness Testers as per IS 1586, ISO 6508, ASTM E18 • Brinell Hardness Testers as per IS 1500, ISO 6506, ASTM E10 • Vickers Hardness Testers as per IS 1501, ISO 6507, ASTM E92, ASTM E384 * Load cells (Class 0.5, AA) used to certify your machines are traceable to FRI (Fie Research Institute, Ichalkaranji) to the current revision as per above standards required. Plausible Instruments Private Limited offers on-site Uni-axial Static Hardness Testing Machines calibration. PI uses Force verification as per the applicable IS/ISO/ASTM Standards, Linear Measurement of Travel of UTM Crosshead (Encoder), Crosshead Travel of Spring Testing Machine as per the applicable ASTM, Long Travel Extensometers L.C. 0.001 mm verification as per the applicable IS/ISO & ASTM & Verification of Speed of Crosshead travel of Uniaxial Testing Machines as per the applicable ASTM standard. • Calibration facility of Uniaxial Testing Machines, 5N to 2000 kN in compression mode and 5N to 100 kN in tension mode as per Latest published IS 1828/ISO 7500/ ASTM E4 standards. • Speed and Displacement of Cross head of Uniaxial Testing Machines as per ASTM E2309, ASTM E2309M. • Extensometer Calibration Up to 25mm as per IS 12872 / ISO 9513 / ASTM E83. * Our CMC (Calibration Measurement Capability) from 5N to 100kN for tension & compression mode ±0.26% & from 100kN to 2000kN for Compression mode ± 030% accredited by NABL - INDIA (National Accreditation Board for Testing & Calibration Laboratory) as per ISO / IEC 17025: 2017 Verification of all sorts of Civil industrial templates (i.e., Test Sieves, Moulds, Slump Cone, Elongation & Flakiness Gauges, Jigs & Fixtures) up to 300mm as per IS/ISO.
