J&A service is a professional oil and gas service company. We perform completion, flowback, and production operations for exploration & production companies. Our initial completions operation is frac support. Frac packages vary per client requirements. A general frac package consists of 1502 iron, a choke manifold, and client assigned equipment for screen outs and bleed off as needed. During the frac, a wireline company sets plugs at target depths the client has determined, to isolate each zone where the frac has been completed. Often, we will rig up a frac isolation package on nearby locations that are close enough to have communication issues with the well that’s being fracked. This package contains 1502 iron, a choke manifold, a sand trap, and J&A personnel to monitor well pressures. J&A service rigs up and down all our equipment for all phases of operations. Once the frac is complete the next phase of completion operations is the drill out. A general drill-out package consists of 1502 iron, a choke manifold, a trash catcher and for some clients, a sand trap and separator that J&A also provides. During a drill out, a work over rig or coil tubing unit will drill each individual plug in the well to convert several zones into one continuous well bore. The number of plugs that separate each zone varies well to well. We assist the work over rig or coil tubing unit during drill out operations to maintain flow rates and circulation while they drill out plugs. During drill outs the well flows sand, plug parts, water, and many times oil and gas through the J&A surface equipment. The trash catcher is used to collect the plug parts that are being milled into smaller pieces by the work over rig or the coil tubing unit. When oil and gas are expected, a J&A separator will be an essential part of the equipment package. The separator is used to divide oil, water, and gas. The oil and water are sent to holding tanks. The gas is incinerated through a controlled flare, or sent to
